100A to 200A main service panel upgrades
New 200A meter main or panel, grounding and bonding brought to current code, and the PG&E application handled for overhead and underground services.
About panel upgradesFacing home insurance non-renewal because of knob and tube in Alameda or Contra Costa County? We provide certified inspection letters and turnkey replacement. How the insurance letter works
Alameda has one of the largest collections of Victorian homes in the Bay Area. Many still have knob and tube, fuse panels or service far too small for modern loads.
Alameda's Victorians often have tall walls and decorative plaster, so we plan wiring routes through basements and attics to protect them.
Three answers, then a planning timeline for your city.
Your timeline appears here once all three are answered.
Alameda is served by Alameda Municipal Power, not PG&E, so service upgrades are coordinated with AMP. Its process and timing differ from PG&E's.
New 200A meter main or panel, grounding and bonding brought to current code, and the PG&E application handled for overhead and underground services.
About panel upgradesFull rewiring that works around lath and plaster, plus a written compliance letter your insurance underwriter can accept.
About knob & tube removalSpan and other load-managing panels that can let a home add an EV charger or heat pump without a full service upgrade, when the load calculation supports it.
About smart panelsSafe generator hookups for PG&E shutoffs and outdoor emergency disconnects for homes in Orinda, Moraga, Kensington and the Oakland and Berkeley hills.
About generator transfer switchesReplacement of Federal Pacific Stab-Lok and Zinsco panels, brands with well-documented breaker problems that many insurers and home inspectors flag.
About fpe & zinsco replacementWe measure what the home draws today and what it will draw after EVs, heat pumps or remodels, and size the service to match.
We pull the permit and file the Alameda Municipal Power application, then coordinate the disconnect date for overhead or underground service.
New meter main or panel, service entrance, and grounding and bonding brought to current code, usually in one working day.
We meet the inspector, get the green tag, and Alameda Municipal Power restores power to the new service.
Family-owned in Richmond since 2002
Electrical work since 2002 and solar since 2010, from the same family.
California C-10 license #806465
Verify it any time on the Contractors State License Board site.
$2M general liability
Certificate of insurance available on request before work starts.
First-inspection guarantee
If your work doesn't pass the first city inspection, we fix it and schedule the re-inspection at no cost.
Electrical permits for Alameda homes are issued by City of Alameda Permit Center. We pull the permit, schedule the inspection and meet the inspector on site.
Plan on 5–15 business days for the permit and roughly 4–12 weeks for Alameda Municipal Power planning when the service itself changes. The on-site work is usually one to two days. We confirm your actual timeline after the site visit.
Alameda Municipal Power, the city's own utility, instead of PG&E. We coordinate the disconnect and reconnect with AMP directly.
Insurers in California increasingly decline or non-renew homes with active knob and tube wiring. We inspect the home and give you a written letter describing what's there. Once we remove it, we issue a completion letter with the finaled permit, which is what most underwriters ask for to reinstate or write a new policy.
The main cost drivers are whether the panel stays in place or moves, overhead versus underground service, grounding and bonding corrections, and whether stucco, siding or drywall needs opening. We give a fixed written price after a free site visit, including permit and PG&E coordination.